Goodmorning all,
After I saw on my ultragauge that the intake temp was going way to high, I ordered a new intercooler pump. Yesterday evening I installed the new. Before connecting I tested the old one en didn't turn over. At the plug I had +13.71Voltage so that's OK. Plugged in the new one and checked to the thing to see the water jet => and NO didn't see anything happen.
The top thing refilled with water to the max indicator. When I push on the hose one the right side of the intercooler box I see a water jet coming out. So that hole isn't blocked. after short testdrive temps did go sky high again => the system isn't working.
Does the system need to be bleeded after changing the pump? How do I do that?
Thx for advice.
After I saw on my ultragauge that the intake temp was going way to high, I ordered a new intercooler pump. Yesterday evening I installed the new. Before connecting I tested the old one en didn't turn over. At the plug I had +13.71Voltage so that's OK. Plugged in the new one and checked to the thing to see the water jet => and NO didn't see anything happen.
The top thing refilled with water to the max indicator. When I push on the hose one the right side of the intercooler box I see a water jet coming out. So that hole isn't blocked. after short testdrive temps did go sky high again => the system isn't working.
Does the system need to be bleeded after changing the pump? How do I do that?
Thx for advice.
Comment